To replace the component, reverse the removal procedure.
Removing and replacing the front I/O assembly
Removing and replacing the front I/O assembly
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
Procedure
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide
100