Removing And Replacing The System Fan - HP ProLiant ML30 Gen10 Plus Maintenance And Service Manual

Removing and replacing the system fan

Removing and replacing the system fan
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. Disconnect the system fan cable .
7. Remove the system fan:
a. Remove the fan screws (callout 1).
b. Remove the fan from the chassis (callout 2).
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 65