Table of Contents
Advertisement
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. If installed, remove the air baffle .
7. If installed, remove the PCI fan.
8. Disconnect the front I/O cable from the system board .
9. Remove the ambient temperature sensor cable from the clips.
10. Press the front I/O bracket on both the ends from inside of the chassis (callout 1), and then remove the front I/O bracket (callout 2).
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide
101
Advertisement
Table of Contents
Troubleshooting
