D-Link DES-3010G Command Line Interface Reference Manual page 26

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
config ports
Restrictions
Example usage:
To configure the speed of ports 1-3 to be 10 Mbps, full duplex, learning and state enabled:
DES-3026:4#config ports 1-3 speed 10_full state enable
Command: config ports 1-3 speed 10_full state enable
Success.
DES-3026:4#
show ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the configuration of ports 1-5 on the Switch:
DES-3026:4#show ports 1-5
Command: show ports 1-5
Port Port
---
1
2
3
4
5
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
Example usage;
To display port descriptions:
description <desc 32> - Enter an alphanumeric string of no more than 32
characters to describe a selected port interface.
clear – Enter this command to clear the port description of the selected
port(s).
Only administrator-level users can issue this command.
Used to display the current configuration of a range of ports.
show ports {<portlist>} {description}
This command is used to display the current configuration of a range
of ports.
<portlist> − Specifies a port or range of ports to be displayed.
{description} – Adding this parameter to the command will allow the
user to view previously configured descriptions set on various ports
on the Switch.
None.
Settings
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
-------- ---------------------
Enabled Auto/Enabled
Enabled Auto/Enabled
Enabled Auto/Enabled
Enabled Auto/Enabled
Enabled Auto/Enabled
Connection
---------------------
100/Full/none
Link Down
Link Down
Link Down
Link Down
24
Address
--------
Enabled
Enabled
Enabled
Enabled
Enabled