Config Bandwidth_Control; Show Bandwidth_Control; To Configure Bandwidth Control; To Show The Scheduling Mechanism - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
Example Usage:

To show the scheduling mechanism:

DES-3026:4#show scheduling_mechanism
Command: show scheduling_mechanism
Scheduling Mechanism : strict
DES-3026:4#

config bandwidth_control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure bandwidth control:

DES-3026:4#config bandwidth_control 1-10 rx_rate 100000 tx_rate 100000
Command: config bandwidth_control 1-10 rx_rate 100000 tx_rate 100000
Success.
DES-3026:4#

show bandwidth_control

Purpose
Used to configure bandwidth control on a by-port basis.
config bandwidth_control [<portlist>] {rx_rate [no_limit |
<value 64-1024000>] | tx_rate [no_limit | <value 64-
1024000>]}
The config bandwidth_control command is used to configure
bandwidth on a by-port basis.
<portlist> − Specifies a port or range of ports to be configured for
bandwidth control.
rx_rate − Specifies that one of the parameters below (no_limit or
<value 64-1024000>) will be applied to the rate at which the
above specified ports will be allowed to receive packets
no_limit − Specifies that there will be no limit on the rate
of packets received by the above specified ports.
<value 64-1024000> − Specifies the packet limit, in kbps,
that the above ports will be allowed to receive.
tx_rate − Specifies that one of the parameters below (no_limit or
<value 64-1024000>) will be applied to the rate at which the
above specified ports will be allowed to transmit packets.
no_limit − Specifies that there will be no limit on the rate
of packets transmitted by the above specified ports.
<value 64-1024000> − Specifies the packet limit, in kbps,
that the above ports will be allowed to transmit.
Only administrator-level users can issue this command.
Used to display the bandwidth control configuration on the Switch.
82