Show Snmp Traps; Config Snmp System_Contact; To View The Current Snmp Trap Support - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

show snmp traps

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To view the current SNMP trap support:

DES-3026:4#show snmp traps
Command: show snmp traps
SNMP Traps
Authenticate Trap
DES-3026:4#

config snmp system_contact

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch contact to "
Used to show SNMP trap support on the Switch .
show snmp traps
This command is used to view the SNMP trap support status
currently configured on the Switch.
None.
Only administrator-level users can issue this command.
: Enabled
: Enabled
Used to enter the name of a contact person who is responsible for
the Switch.
config snmp system_contact {<sw_contact>}
The config snmp system_contact command is used to enter the
name and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 255 character can be
used.
<sw_contact> - A maximum of 255 characters is allowed. A NULL
string is accepted if there is no contact.
Only administrator-level users can issue this command.
M I S D e p a r t m e n t I I
DES-3026:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3026:4#
":
45