Show Lacp_Port; To Configure Lacp Port Mode Settings; To Display Lacp Port Mode Settings - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
config lacp_ports
Restrictions
Example usage:

To configure LACP port mode settings:

DES-3026:4#config lacp_port 1-6 mode active
Command: config lacp_port 1-6 mode active
Success.
DES-3026:4#

show lacp_port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To display LACP port mode settings:

DES-3026:4#show lacp_port 1-11
Command: show lacp_port 1-11
Port
------
1
2
3
4
5
6
7
8
9
10
11
DES-3026:4#
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices
must support LACP.
passive – LACP ports that are designated as passive
cannot process LACP control frames. In order to allow the
linked port group to negotiate adjustments and make
changes dynamically, at one end of the connection must
have "active" LACP ports (see above).
Only administrator-level users can issue this command.
Used to display current LACP port mode settings.
show lacp_port {<portlist>}
This command will display the LACP mode settings as they are
currently configured.
<portlist> - Specifies a range of ports that will be viewed.
Only administrator-level users can issue this command.
Activity
--------
Active
Active
Active
Active
Active
Active
Passive
Passive
Passive
Passive
Passive
96