Powering On - NEC VERSA MEDIADOCK Service Manual

To verify that the connection is made, open the Versa LCD panel and check the battery
status LCD. The LCD should show that the battery is charging. If it does not, verify that the
AC adapter and power cable are connected properly to the MediaDock. Then pull the
docking lever forward again.
The Versa is now docked. Please note the following.
n
To use the MediaDock, the AC adapter must be connected. The adapter powers
both the MediaDock and the Versa connected to it. The MediaDock cannot run
on the Versa batteries.
n
The first time you connect the Versa and MediaDock, you need to set up the
Versa software to recognize the MediaDock and CD-ROM. Refer to "Software
Setup" later in this section for information.

Powering On

The Versa power button turns power on and off to both the MediaDock and the Versa.
Turn power on as follows:
Connect the AC adapter to the MediaDock and dock the Versa as described in the
1.
two preceding sections.
Open the LCD, locate the power button on the Versa.
2.
Setup and Operation 2-5