Appendix A Software Setup For Customized Disks; System File Modification; Modifying The Config.sys File - NEC VERSA MEDIADOCK Service Manual

Appendix A
Software Setup for Customized Disks
Use the setup procedures in this section under the following circumstances:
n
You are using a hard disk other than the one that came with the Versa.
n
You loaded or reloaded the operating system on the hard disk.
In addition to the procedures in Section 2, software setup for customized drives requires
that you modify the CONFIG.SYS and AUTOEXEC.BAT system files. After these files are
modified, return to Section 2 and run the MediaDock Setup utility as described.

SYSTEM FILE MODIFICATION

Instructions for modifying the CONFIG.SYS and AUTOEXEC.BAT files follow.

Modifying the CONFIG.SYS File

The MediaDock Setup utility creates a second configuration for use with the MediaDock.
The utility locates labels in the CONFIG.SYS file and loads information below the label.
Modify the CONFIG.SYS file to insure that the correct labels are in place.
The procedure that follows creates four labels that are essential to MediaDock setup. Sim-
ply follow the instructions in the order presented. (If a label already exists in your file, you
do not need to re-enter it.) For details, see the MS-DOS user's guide that came with the
Versa.
After completing the procedure, the file will contain information similar to that shown in the
following example. Bold type represents text entered during the following procedure.
[COMMON]
DOS=HIGH,UMB
FILE=30
BUFFERS=10
STACKS=9,256
DEVICE=C:\DOS\HIMEM.SYS
DEVICE=C:\EMM386.EXE NOEMS X=D000-FCFF I=B000-B7FF
DEVICE=C:\DOS\SETVER.EXE
SHELL=C:\DOS\COMMAND.COM C:\DOS /P
[MENU]
MENUITEM=MOBILE, Mobile Configuration