Running The Mediadock Setup Utility - NEC VERSA MEDIADOCK Service Manual

2-14 Setup and Operation

Running the MediaDock Setup Utility

This section describes how to use the MediaDock Setup utility. While running the utility,
use the following options:
n
To stop the installation, press
n
To accept default settings, press
prompts.
n
To change settings, follow the on-screen instructions.
Before running the MediaDock Setup utility, make sure to enable the MediaDock through
the ACU. This procedure is described earlier in this section, "Running the ACU."
Run the MediaDock Setup utility as follows.
1. Type win and press
Close any Windows applications that may be running (for example, CardView).
2.
Insert the first MediaDock Setup diskette into the drive.
3.
4. From the Windows Program Manager, access the File pull-down menu and select
"Run".
5. Type a:winstall
6. Respond to the utility prompts as follows:
n
Click "OK" to continue after reading the ACU reminder screen.
n
Click "OK" or press
aDock Setup Utility introduction screen.
n
Specify the disk drive on which to install the software. Press
"OK" to accept the default drive c:.
n
Specify the subdirectory in which to install the software. Press
"OK" to accept the default subdirectory MEDIADOK. The utility copies the
required software into the specified subdirectory.
7. If you are using a Versa P, exit Windows and reboot your system to activate the
CD-ROM. The Versa P and MediaDock are now ready to use together.
If you are using an UltraLite Versa, Versa E, Versa M, or Versa V, proceed as
follows at the prompt:
n
Remove the setup diskette, insert Audio Applications diskette 1 into the drive,
and press
Esc .
Enter
Enter to open Windows.
and press Enter .
to continue with the setup after reading the Medi-
Enter
.
Enter
click "OK," or click "Continue" at the
,
Enter or click
Enter or click