Running The Acu For The Versa V - NEC VERSA MEDIADOCK Service Manual

n
Shut off system power after boot up. Restart the system and press
the cursor changes to a blinking block to go back into the ACU.
n
From the main ACU screen, press
n
Enter the appropriate time and date. Press
date and return to the main ACU screen.
n
Press . Select "Exit and Save Changes" and press
X
n
Press
Enter
exit Windows and turn off system power.
2. Connect the MediaDock to the AC adapter and an outlet, and dock the Versa.
3. Power on and boot up the Versa.
When the cursor changes to a blinking block, press
4.
From the main ACU screen, press
5.
6. From the Disk Drive Settings screen, press the down arrow or
sor to the selection arrow next to "IDE Hard Disk Interface."
7. Press Alt- .
8. Use the cursor down arrow to select "Internal/Docking Station" and press
Press
9. Enter
Press .
X
Select "Exit and Save Changes" and press
10.
update your system.
To continue, go to "Start-Up Diskette Creation" later in this section.

Running the ACU for the Versa V

This section describes running the ACU for Versa V users.
Connect the MediaDock to the AC adapter and an outlet, and dock the Versa.
1.
2. Power on and boot up the Versa.
3. The cursor changes to a blinking block. From the main ACU screen, press
to access power management options.
n
Press
Alt-
n
Use the down arrow to select "Off." Press
ACU screen.
at the prompt to update your system. Once boot up completes,
Four options appear.
again to exit the Drive menu and return to the main ACU screen.
to access power management settings.
Setup and Operation
T to access the time and date screen.
to accept the new time and
Enter
Enter
to access the ACU.
F1
to access the Drives menu.
D
. Press
Enter
twice to return to the main
Enter
2-11
F1 when
.
i to move the cur-
Enter
at the prompt to
Enter
P twice
.