Log In and Configuration
In this chapter
PowerConnect B-DCX-4S Configuration Overview
NOTE
If the Brocade FS8-18 encryption blade is installed, refer to the Fabric OS Encryption Administrator's
Guide for the procedures to configure the encryption functions.
The PowerConnect B-DCX-4S must be configured before it is connected to the fabric, and all of the
configuration commands must be entered through the active CP blade. The PowerConnect
B-DCX-4S configuration includes the following parameters:
•
•
•
•
•
The PowerConnect B-DCX-4S WWN is initially set by the factory to match the license ID (which is
based on the chassis serial number). The WWN can be changed but the license ID cannot be
modified.
PowerConnect B-DCX4S Backbone Hardware Reference Manual
53-1001808-01
•
•
•
•
•
•
•
•
•
Setting the domain ID . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
•
•
Software licenses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
•
•
•
Managing cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
•
IP address and subnet mask for the chassis
IP addresses, host names, subnet masks, and gateway addresses for both CP blades
Switch name
Domain ID (optional)
WWN (optional)
Chapter
3
17