Time and items required
The replacement procedure for the cable management fingers takes less than five minutes. A #1
Phillips screwdriver is required.
Removing a cable management finger assembly
1. Rearrange the cables around one of the cable management finger assemblies.
2. Unscrew and save the three (3) screws holding the finger assembly to the rack upright
3. Remove the cable management finger assembly.
4. If necessary, repeat steps 1-3 for the other finger assembly.
FIGURE 20
Replacing a cable management finger assembly
1. Position and tighten the three (3) screws to secure the vertical cable management finger
2. Arrange the cables along the cable management finger assembly.
3. If necessary, repeat steps 1-2 for the other cable management assembly.
PowerConnect B-DCX-4S Backbone Hardware Reference Manual
53-1001808-01
(Figure
20). Support the assembly to prevent it from falling.
RRP: Vertical cable management finger assemblies
assembly to the rack upright.
RRP: Vertical cable management fingers
5
45