5
RRP: Control processor blade (CP8)
FIGURE 22
Replacing a filler panel
1. Orient the filler panel
2. Slide the filler panel into the slot until it is firmly seated.
3. Tighten the thumb screw at the right of the panel.
4. Replace the chassis door
RRP: Control processor blade (CP8)
This section describes how to remove and replace a control processor (CP8) blade. Each
PowerConnect B-DCX-4S has two CP8 blades located in slot 4 and slot 5.
NOTE
If the new CP blade does not have the same firmware as the active CP blade, the new blade must
be upgraded to the same firmware version. Refer to the Fabric OS Administrator's Guide for
information.
Time and items required
The replacement procedure for the CP blade takes approximately 30 minutes. The following items
are required for the CP blade replacement:
50
RRP: Blade filler panel
(Figure
22).
("RRP: Chassis
door").
PowerConnect B-DCX-4S Backbone Hardware Reference Manual
53-1001808-01