Winding The Lower Thread - Brother BAS-364E Instruction Manual

4. Winding the lower thread

Do not touch any of the moving parts or press any objects against the machine while the bobbin is turning,
as this may result in personal injury or damage to the machine.
Note
Do not touch the bobbin or the bobbin holder while the bobbin is turning, otherwise injury may result.
q
series
1. Slide the bobbin all the way onto the spindle.
2. Thread the thread as shown in the illustration (in the case of the BAS-364E and 366E, there is no lower thread
guide u), wind the thread around the bobbin several time in the direction shown by the arrow, and then press the
bobbin presser q.
3. Turn the power switch w on.
The power indicator on the operation panel will light.
G
4. Press and hold the STEP BACK switch e on the operation panel, and depress the start switch r to start the
sewing machine.
Keep the start switch depressed until the bobbin is fully wound.
G
Release the STEP BACK switch e when the sewing machine starts.
G
5. The bobbin holder q will automatically return when the bobbin is filled to capacity (approximately 80 - 90 % of the
bobbin diameter).
6. Release the start switch r.
7. Remove the bobbin, and pull the bobbin in the direction of the arrow to cut the thread on the thread cutter t.
8. To wind more thread onto the bobbin, loosen the set screw y and move the bobbin holder q out in the direction of
the arrow.
CAUTION
e
BAS-364E, 366E, 370E, 375E
Chapter 4 CORRECT OPERATION
w
t
r
O N
O F
F
y
q
14