Brother BAS-364E Instruction Manual page 26

!0 Bobbin Thread COUNTER ..........
indicator
!1 SPLIT NO. indicator .....................
!2 Dial ..............................................
!3 Bobbin Thread SET switch ..........
!4 Bobbin Thread CHANGE .............
switch
!5 TEST switch ..................................
!6 TEST indicator ..............................
!7 STEP BACK switch ......................
Illuminates when bobbin thread counter mode has been selected using the
menu switch y.
Illuminates when split No. mode has been selected using the menu switch y.
The setting shown on the display screen t can be changed by turning this dial
while pressing the STEP BACK switch !7 7 7 .
Used to store the number of work pieces displayed in the bobbin thread counter
to floppy disk.
Used to continue sewing after replacing the bobbin thread.
(An alarm will sound when the counter reads <000>. Sewing is not possible
when the counter reads <000>.) (Refer to "10. Using the bobbin thread
counter".)
Used to move the feed mechanism only in order to confirm a programmed
stitch pattern.
Lights when the TEST switch is pressed.
Used when winding a fresh bobbin, or when correcting a stitch pattern due to
a broken needle thread.
BAS-364E, 366E, 370E, 375E
Chapter 5 OPERATING PROCEDURE
20