Using The Step Back Switch - Brother BAS-364E Instruction Manual

Chapter 5 OPERATING PROCEDURE

8. Using the STEP BACK switch

Do not touch any of the moving parts or press any objects against the machine while sewing, as this may
result in personal injury or damage to the machine.
This switch is used to move the machine one stitch at a time in the reverse sewing direction to enable resewing
in the event the thread breaks or the bobbin thread runs out in mid-pattern. Use this switch to return to the
point where the thread broke or ran out.
q
w
!6
!5
27
CAUTION
!7
e
BAS-364E, 366E, 370E, 375E
1. Press the emergency, stop switch q while the machine
is running. (All operations will stop and the emergency
stop lamp will illuminate.)
2. Press the reset switch w.
(The emergency stop lamp will go out.)
3. Press the STEP BACK switch !7 . (The work clamp will
move stitch by stitch in the opposite direction while the
STEP BACK switch !7 is being pressed.)
4. When the work clamp has returned to the desired
position, release the STEP BACK switch !7.
(If the work clamp is stopped too soon, press the
STEP BACK switch !7 again to resume work clamp
movement.)
5. The machine will start sewing when the start switch e
is pressed.