Chapter 3 Installation; Connecting The Ground Wire; Positioning - Brother BAS-364E Instruction Manual

Chapter 3 INSTALLATION

Chapter 3 INSTALLATION
Machine installation should only be carried out
by a qualified technician.
Contact your Brother dealer or a qualified
electrician for any electrical work that may need
to be done.
The sewing machine head weighs more than
65 kg. The installation should be carried out by
two or more people.
Do not connect the power cord until installation
is complete, otherwise the machine may operate
if the foot switch is depressed by mistake, which
could result in injury.
Be sure to connect the ground. If the ground
connection is not secure, you run the risk of
receiving a serious electric shock.

1. Connecting the ground wire

Be sure to connect the gound. If the ground connection is not secure, you run the risk of receiving a serious
electric shock.

2. Positioning

Note
Disconnect the power supply from the special socket afrer install has been completed.
G
Be sure to connect the ground. If it is not connected, damage to the machine, incorrect operation and electric
G
shocks may result.
w
q
3
Red
3-phase
White
power supply
Black
Green/Yellow
....... Connect to ground
BAS-364E, 366E, 370E, 375E
CAUTION
Be sure to wear protective goggles and gloves
when handling the lubricating oil and grease,
so that they do not get into your eyes or onto
your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the
grease under any circumstances, as they can
cause vomiting and diarrhoea.
Keep the oil out of the reach of children.
Avoid setting up the sewing machine near
sources of strong electrical noise such as
highfrequency welding equipment.
If this precaution is not taken, incorrect machine
operation may result.
DANGER
Connection method for 3-phase power supply
Decide the position for the sewing machine. Loosen nuts
of six level adjusters q. Lower the level adjusters and
secure them with nuts w. Turning the level adjuster
counterclockwise will raise its height and turning it
clockwise will lower it.
Note
If the level adjusters are not secured properly, the
machine may move during operation, which could
result in injury or damage.