Table of Contents
Advertisement
Introduction (continued)
(5) Slowly slide the module into place (in the direction of the arrow). Make sure that the DVI port
is correctly aligned. (Please take care not to cause damage to the projector by the clasp.)
Insert the two module locking screws into the respective DVI port.
[(7) Tighten the screws]
(6) Tighten (turn right) the two DVI port locking screws.
(7) Tighten the clasp to the projector using the accompanying locking screws (M3x8).
(8) Firmly connect the module's power cable to the projector's power port
(9) Reattach the projector's filter cover.
Filter cover
Power port
Advertisement
Table of Contents
