Table of Contents
Advertisement
Confirming the Connection to the Projector
Once you have completed mounting the WNM80 module onto the projector, follow the below instructions to
make sure that the connection to the projector is working okay. During this confirmation, you will check to see:
• Whether or not the WNM80 module is correctly recognized when the projector's menu is displayed
(1) Turn on the projector's power.
(Turn on the projector's AC switch and press the STANDBY button.)
(2) Select DVI using the projector's jog dial button or by pressing the WIRELESS button on the
projector's remote control.
(3) Use the remote control or the projectors
operation panel to open the WIRELESS
menu (refer to the projector's user guide
as necessary):
• Press the MENU button.
• Press the button until the cursor is over
WIRELESS.
©
(4) Press the
button.
(6) After a moment, the network information will be displayed as shown below. Confirm the network information.
Press the stick for
ENTER move up for
or down for
.
©
button
WIRELESS button
(5) Press the
button twice.
NOTE
If the information is not displayed, check the
connection between the WNM80 module and the
projector.
LASER
INDICATOR
STANDBY/ON
VIDEO
RGB
UP
FOCUS
ZOOM
PAGE
DOWN
BLANK
LASER
©
ASPECT
MENU
button
PUSH
ENTER
ESC
MENU
RESET
RESET
POSITION
AUTO
PinP
button
MAGNIFY
VOLUME
ON
FREEZE
MUTE
OFF
WIRELESS
KEYSTONE
ONE TOUCH
button
Advertisement
Table of Contents
