Hitachi WNM80 User Manual page 39

(6) [DHCP (Dynamic Host Configuration Protocol)]
(7) [WIRELESS MODE]
INFRASTRUCTURE: Use this setting when you will be connecting the WNM80 module to your network via an
access point to connect to a PC (connection to multiple PCs possible in this mode).
NOTE
Consult with your network administrator before connecting to an existing access point in your
network.
(8) [CH (Channel)]
(9) [WEP Mode (Wired Equivalent Privacy)]
(10) [Do you want to save the changes?]
Select YES and press ENTER to apply the changes. Select NO and press ENTER if you
This setting is used to determine whether to have this
device's IP address assigned automatically by the network's
DHCP server or to assign the IP address manually. The
factory default is to leave this setting "OFF" and assign the
IP address manually. If this setting is set to "ON," the DHCP
server will automatically assign an IP address to this device
and so the manually set IP address will be ignored.
Sets the communication mode to be used for wireless
communication.
The factory default setting is 802.11 AD-HOC.
AD-HOC or 802.11 AD-HOC: You can use either of these when
you will only be connecting the WNM80 module and your PC.
Configure it so that the settings match your PC settings. This is
usually the connection type used for one-to-one connections
between the WMN80 module and a PC. However, the WNM80
module is capable of recognizing up to four PCs at a time.
The wireless LAN (IEEE802.11b) device can
communicate on channels 1 to 11. The factory default
is channel 10. If you are using an access point,
configure the channel setting to the channel specified
by the access point. If you aren't using an access
point, configure the channel setting to the PC you are
using.
An encryption method used for wireless
communication. The factory default is OFF.
OFF: Encryption will not be used.
40bit: A 10-character (hexadecimal) encryption key
will be used.
128bit: A 26-character (hexadecimal) encryption
key will be used.
don't wish to apply the changes.