Hitachi WNM80 User Manual page 33

Wireless network module
Table of Contents

Advertisement

The Status Menu
The Status menu is used to monitor the projector's status.
[Temp] Indicates the status of the projector's internal temperature.
OK: The temperature is fine.
Warning: The projector's filter is dirty. Clean the filter. Replace the filter if necessary.
Error: The temperature is abnormally high.
If this error persists even after you replace the filter, contact your local service
representative.
Failed: The projector has most likely broken down.
Contact your local service representative.
[FAN] Indicates the status of the projector's internal fan.
OK: The fan is fine.
Error: The fan has errored out. Check for foreign objects in the fan.
If the fan is free from foreign objects, contact your local service representative.
[Input] Indicates the currently selected video source.
RGB
RGB2
Component
To alter the video source, press the M button to select the desired video source and then click
the set button.
[Lamp time] Indicates the amount of time the lamp has been in running (in hours).
[auto refresh] If this is set to on, the WNM80 module will automatically check the projector's status
every 30 seconds.
If this is set to off, the WNM80 module will only check the projector's status one time
(when this dialog is first opened).
So, for example, if you set this to off, and then use the remote control to toggle the
video input state, this dialog will not automatically reflect the change.
[Power] Indicates the power status.
Standby: The projector is in standby state (projector lamp off).
ON:
The projector's power is on (projector lamp on).
To alter the projector's power state, press the M
button to select the desired state and then click the
set button.
[Lamp] Indicates if there is a projector lamp error or not.
OK: There are no errors.
Change the Lamp: Time to replace the projector's lamp.
Cover Open: The projector lamp's cover is open.
Error: The lamp isn't on and is in an error state.
Contact your local service representative.
DVI
S-Video
Composite
Replace the projector's lamp.
Close the cover.

Advertisement

Table of Contents
loading

Table of Contents