Sharp AR-FX10 Operation Manual page 34

TRANSMISSION AND RECEPTION USING THE POLLING FUNCTION
USING THE POLLING FUNCTION
A document should not be loaded in the machine when the following operation is performed. When used in
conjunction with the timer transmission function, only one polling job can be stored.
NOTE
If the other machine has a polling security function (refer to "Restricting polling access (polling security)" on page
3-8), use the key operator program to program your own fax number (refer to "Own number and name set" page
8-5), and ask the operator of the other machine to appropriately program your fax number in that machine.
1 In fax mode, touch the [SPECIAL MODES]
key and then touch the [POLLING] key.
SPECIAL MODES ADDRESS REVIEW
POLLING
DUAL PAGE
PROGRAM
SCAN
To cancel polling, touch the [POLLING] key once
again so that it is not highlighted.
2 Touch the [OK] key.
AKER REDIAL
OK
BER
NOTE
To cancel the operation
Press the [JOB STATUS] key and then cancel the operation. (See "CANCELLING A FAX TRANSMISSION" on page 2-6.)
I I I I Manual polling
A document should not be loaded in the machine when the following operation is performed. Manual polling is
begun on the signal of the other party.
1 Touch the [SPEAKER] key in fax mode,
and dial the number of the other machine.
SPEAKER
FAX MEMORY:100%
ADDR
AUTO RECEPTION
DIRE
SUB
2 Touch the [SPECIAL MODES] key.
AUTO RECEPTION
DIRE
SUB AD
SPECIAL MODES ADDRESS
3-6
If the address directory
screen appears, touch the
[CONDITION SETTINGS]
key to display the condition
settings screen (page 1-5).
The [POLLING] key is
highlighted and the
polling icon appears.
You will return to the
initial screen.
A one-touch key or the
RE
[REDIAL] key can also
be used.
DD
If the address directory
screen appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-5).
3 Dial the number of the other fax machine
or touch an auto-dial key (one-touch or
group key) (refer to page 2-3).
SPE
CORPO.TPS
SHARP GROUP
repeat this step. (See step 3 on page 3-3)
NOTE
When performing serial polling, an auto-dial key that includes
a sub-address or passcode (page 4-2) cannot be selected.
4 When you have finished entering the
destination(s), press the [BLACK COPY
START] key.
3 When you hear the fax tone from the other
machine, touch the [POLLING] key.
ER POLLING
L PAGE
PROGRAM
SCAN
4 Polling reception begins.
Your machine prints the fax after receiving it from
the sending machine.
NOTE
Serial polling cannot be performed manually. When
polling reception ends, repeat steps 1 through 4.
If the condition settings screen
appears, touch the [ADDRESS
DIRECTORY] key to display
the address directory screen.
(See 1-4 page.)
If you are performing serial
polling, touch the [NEXT
ADDRESS] key and
"JOB STORED." appears
in the touch panel.
The fax is received from
the other machine and
printed out.
"JOB STORED." appears
in the touch panel.