Programming Frequently Used Operations; G Using A Program; Using A Program - Sharp AR-FX10 Operation Manual

PROGRAMMING FREQUENTLY USED OPERATIONS

This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. This function is convenient when you frequently send documents, such as a daily report, to the same
destination. Up to eight programs can be stored.
Programs can be stored using the custom settings, and a name up to 18 characters long can be assigned.
For information on storing, editing, and deleting programs, refer to "STORING A PROGRAM", and "EDITING
AND DELETING PROGRAMS" on page 6-8.
The following settings can be stored in a program:
Destination fax number
G
Auto-dial keys (one-touch or group keys) are used to store the destination fax number. A full number cannot be
entered using the numeric keys. When storing a broadcast transmission or serial polling operation in a program, up
to 300 destination fax numbers can be stored.
NOTES
G A program differs from a timer transmission (page 3-4) in that it is not cleared from memory after transmission
takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however,
that programs do not allow you to establish a timer setting for transmission.
G With the exception of polling, reception operations cannot be stored in a program.

USING A PROGRAM

1 In fax mode, load the document (page 1-7).
2 Touch the [SPECIAL MODES] key and
then the [PROGRAM] key.
SPECIAL MODES ADDRESS REVIEW
POLLING
DUAL PAGE
PROGRAM
SCAN
3 Touch the program key you wish to
execute. Make sure the key is highlighted
and then touch the [OK] key.
OK
G.
RAM1
Polling Dual Page Scan
G G
Do not load a document
if you are performing a
polling operation.
If you are going to use Dual
Page Scan (page 3-10),
place the document on the
document glass.
If the address directory
screen appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-5).
The program key you
touched is selected and
you return to the screen
of step 2.
The [PROGRAM] key is
highlighted.
Resolution and exposure
G
4 Touch the [OK] key.
AKER REDIAL
OK
BER
5 If needed, set the original size and other
settings, and then press the [BLACK
COPY START] key.
Transmission takes place according to the
program.
NOTE
Select functions that cannot be stored in a program
before you press the [BLACK COPY START] key in
step 5. These functions include specifying the
original size (See "MANUALLY SETTING THE
SCANNING SIZE" on page 1-8.), two-sided
scanning (See "FAXING A TWO-SIDED ORIGINAL"
on page 2-4.), and timer transmission. (See "TIMER
TRANSMISSION" on page 3-4.)
You will return to the
initial screen.
3-11
3