G Setting For F-Code Relay Broadcast Memory Boxes (Recipient); Setting For F-Code Relay Broadcast Memory Boxes (Recipient) - Sharp AR-FX10 Operation Manual

SETTING FOR F-CODE RELAY BROADCAST MEMORY
BOXES (RECIPIENT)
Program the end receiving machines to which document data received in the F-code relay broadcast memory box
will be transmitted when your machine is a relay machine.
NOTES
G Up to 30 end receiving machines (30 one-touch keys or group keys) can be programmed. If you attempt to
program more than this number, a message will appear and programming will not be possible.
G Only destinations that have been programmed in auto dial keys (one-touch keys or group keys) can be selected.
If you need to include a destination that has not been programmed in an auto dial key, first program it in a one-
touch key (page 6-3) and then program the destination as an end receiving machine.
1 Touch the [RELAY BROADCAST] key in
step 3 of "PROGRAMMING AN F-CODE
MEMORY BOX" on pages 6-10 to 6-11 and
store a box name, sub-address, and
passcode.
Touch the [RECIPIENT] key.
2
FAX INFORMATION
BOX NAME
SUB ADDRESS
123456/987654
RECIPIENT
3 Touch the one-touch keys you wish to
include as end receiving machines.
Touch indexes and the
needed.
DIRECT ADDRESS / GROUP
SELECT ADDRESS.
A B
C GROUP SHARP CORPORATION
CORPO.TPS
FREQUENT USE ABCD EFGHI JKLMN
G The selected one-touch keys are highlighted and
programmed as end receiving machines.
G If you touch an incorrect key, touch the key again to
remove the highlighting and delete the destination.
PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES
The address selection
screen appears.
keys as
ADDRESS REVIEW
OPQRST UVWXYZ
ABC GROUP
4 To check the destinations that have been
selected as end receiving machines,
touch the [ADDRESS REVIEW] key.
N
ADDRESS REVIEW
OPQRST UVWXYZ
ABC GROUP
5 Touch the [OK] key in the screen of step 3.
You will return to the screen of step 2 and the
number of stored as end receiving machines will
appear.
6 To exit, touch the [EXIT] key. To program
another memory box, touch the [NEXT] key.
Touching the [EXIT] key returns you to the screen
of step 3 on page 6-10.
Touching the [NEXT] key returns you to the screen
for programming a new memory box (the screen of
step 4 on page 6-10).
You can delete a
destination from the list of
end receiving machines by
touching it. When the
confirmation message
appears, touch the [YES]
key to confirm the deletion.
6-13
6