Problems And Solutions - Sharp AR-FX10 Operation Manual

PROBLEMS AND SOLUTIONS

If you experience a problem with the fax function, first check the following table. If you cannot solve the problem using
the following table, see chapter 7 of the Operation Manual (for general information and copier operation).
Problem
The machine does not Is the fax power switch turned
operate. on?
Dialing is not possible. Is the telephone line properly
connected?
Is the main switch turned on?
Is the machine in fax mode?
Does the receiving fax machine
have paper?
Does
support G3 transmission?
The receiving machine Are
does not receive your passcode correct?
fax.
Is the receiving machine ready to
receive?
Was the original size detected
correctly?
Was the original placed so that
the correct side is scanned?
The transmitted image
prints out blank at the
If the receiving machine is using
receiving side.
thermal paper, was the thermal
paper loaded with the wrong side
out?
Were line conditions poor due to
thunder or another reason?
The transmitted image
Were
is distorted.
exposure settings suitable?
Transmission does not Is the machine's clock set to the
take place at the correct time?
specified time.
7-4
Check
the receiving machine
the sub-address and
the resolution and
Solution
Turn on the fax power
switch.
Check the connections.
Turn the main switch on.
Press the [IMAGE SEND]
key to set the machine to
fax mode.
Check with the operator of
the receiving machine.
Check the transmittable
sizes.
Make sure the original is
placed so that the correct
side is scanned.
Check with the operator of
the other machine.
Try the transmission again.
Check the resolution and
exposure settings.
Set the clock to the correct
time.
Page
"Fax power switch", page
0-4.
"Line connection", page
0-4.
Operation manual (for
general information and
copier operation), page 1-4.
"BASIC PROCEDURE
FOR SENDING FAXES",
page 2-2.
_
"CHECKING THE SIZE
OF A LOADED
ORIGINAL", page 1-8.
"LOADING A
DOCUMENT", page 1-7.
_
_
"SELECTING RESOLUTION
AND EXPOSURE SETTINGS",
pages 1-9 and 1-10.
Operation manual (for
general information and
copier operation), page 2-13.