G Storing A Group Key; Storing A Group Key - Sharp AR-FX10 Operation Manual

STORING, EDITING, AND DELETING AUTO DIAL KEYS AND PROGRAMS

STORING A GROUP KEY

Up to 300 destinations can be stored in a group key.
To program a group key, follow steps 1 through 3 on page 6-2, touch the [GROUP] key in step 4, and then follow
these steps.
NOTE
Only one-touch key destinations can be stored in a group key. If you wish to store a destination that is not
programmed in a one-touch key, first program the destination in a one-touch key and then store it in the group key.
1 Follow the same steps 1 through 7 of
"STORING ONE-TOUCH KEYS" (pages 6-3)
to enter a [GROUP NAME], [INITIAL], and
[INDEX].
* In step 1 on page 6-3, touch the [GROUP
NAME] key instead of the [NAME] key.
2 Touch the [ADDRESS] key.
AME GROUP-DIGITAL DOCUMENT
X USER 2 ADDRESS
ME
Touch one-touch keys of the destinations
3
that you wish to store in the group.
Touch index keys and the
needed.
DIRECT ADDRESS / GROUP
SELECT ADDRESS.
A B
C GROUP SHARP CORPORATION
CORPO.TPS
FREQUENT USE ABCD EFGHI JKLMN
G One-touch keys that have been touched are
highlighted.
G If you touch the wrong key, simply touch it again to
cancel the highlighting and remove the destination
from the group.
NOTE
Keys that are greyed out are group keys. Group keys
cannot be selected.
G To check the destinations that you have stored in
the group, touch the [ADDRESS REVIEW] key.
N
ADDRESS REVIEW
OPQRST UVWXYZ
ABC GROUP
6-6
keys as
ADDRESS REVIEW
OPQRST UVWXYZ
ABC GROUP
A list of the destinations
appears.
To delete a destination,
touch the key of the
destination and then
touch the [YES] key in
the message that
appears.
4 Touch the [OK] key in the screen of step 3.
G You will return to the screen of step 2. The number of
selected destinations will appear next to the
[ADDRESS] key.
5 Check the name of the key (refer to step 13
on page 6-4).
The characters appearing next to the [KEY NAME]
key will be displayed in the group key. To change
these characters, touch the [KEY NAME] key. This
step is not necessary if you do not wish to change
the characters.
The procedure for
explained on page 6-15.
Touch the [EXIT] key when you have
6
finished programming the group key.
If you wish to program another group key,
touch the [NEXT] key.
When you touch the [EXIT] key, you will return to
the screen of step 4 on page 6-2.
To store another group, touch the [NEXT] key.
entering characters is