Fujitsu Eternus DX80 S2 User Manual page 79

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
6-4
7
8
9
10
11
12
13
14
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Connect the power cord on the power socket side.
Connect the other end of the power cord plug to a power socket or an inlet on the
power distribution unit.
Turn the PSU switches of the power supply units (PSU#0 and PSU#1) in the
drive enclosure to the ON position (marked "|").
The power of the drive enclosure is turned on and the fan revolves at high speed for about
30 seconds.
Check that the LINE LED and the POWER LED on the drive enclosure are lit up.
LINE
FAULT
POWER
FAULT
In the [Add Drive Enclosure] screen, click the [Next] button.
The added drive enclosures are recognized and the installation completion screen
appears.
Click the [Done] button.
The [Add Drive Enclosure] screen closes and the screen display returns to the [Drive
Enclosure] screen.
In the [Storage] screen of [Component], check that the added drive enclosure is
displayed.
To install more additional drive enclosures, repeat
Install the drives.
For details on drive installation, refer to
(page 61).
If a wrist strap is used, remove the wrist strap.
Copyright 2012 FUJITSU LIMITED
Drive enclosure
Controller enclosure
Step 1
"5.1.4 Additional Drive Installation Procedure"
79
to Step 11.
End of procedure
P3AM-4842-03ENZ0