Table of Contents
Advertisement
Chapter 9: Message transfers
[2] Example operation
The example below shows the procedure for using the JW-100SP ladder logic programming software.
For details about the operation of other support tools, see their respective manuals.
1
1
1 Connect a personal computer to the module on the FL-net.
1
1
Connector
for the
programmer
2
2
2
2
2 Communication settings
Set the JW-100SP communication settings to "network" and enable remote programming and
remote monitoring.
Start the JW-100SP
Click [Setting] on the menu bar.
9
Click [Communication setting] on the "Set" menu.
Click on "Network" and then click on "Detail settings."
This
module
ON
S
H
I
E
L
D
OFF
Connection cable
FG
RESET
(JW-22KC/24KC)
(JW-20FL5)
[For connection with the JW-
50FL, use the ZW-3KC.]
The "Set" menu will appear.
The [Communication setting] dialog box will appear.
The [Detail setting] dialog box will appear.
Communication
adapter
(JW-100SA)
9-46
Personal
computer
Ladder
programming
support software
(JW-100SP)
Advertisement
Table of Contents
