Table of Contents
Advertisement
Chapter 4: Name and Function of Each Part
4-4 JW-50FL
8 Switch SW3
(Factory setting: 0)
4
7 Switch SW3
(Factory setting: ON)
Display panel
1
2 Connector for programmer
3 Connector for 10BASE5
4 Connector for 10BASE-T
12 VDC power supply
5
input terminal
6 Reset switch
7 Switch SW2
8 Switch SW3
Note: Only 10BASE5 or 10BASE-T protocol is used. Mixed use of these two types is not permitted.
Name
Displays the JW-50FL operating status using LEDs.
LNK
Lights at operating. Lights OFF at stopping.
TX
Blink at transmitting data.
RX
Blink at receiving data.
12 VDC
Lights when 12 VDC is supplied. (Only when 10BASE5 is used.)
TEST
Lights at test mode.
PER
Lights at parameter setting error.
HER
Lights at this module error.
S0 to S7
Indicates status of connection status monitor flag.
When using a remote monitor or remote programming function, connect
a JW-14PG programmer.
Connect the 10BASE5 transceiver cable.
Make sure to slide the lock securely to the "lock" position.
Connect 10BASE-T twisted-pair cable.
When 10BASE5 is used, connect a commercially available DC power
supply that is designed to supply power to transceivers. The DC power
supply must provide 12VDC 5% and 0.5 A or more.
Only used by SHARP engineers. Users should not press this switch.
Turn ON when the shields on the 10BASE-T connectors or 10BASE5
ON
connectors are connected to the FG (base) of the JW-50FL.
Turn OFF when the shields on the 10BASE-T connectors or 10BASE5
OFF
connectors are not connected to the FG.
- Ground the FG line on the 12 VDC connector separately.
Specify a parameter address (in system memory) from 0 to 4.
- See page 12-4.
1 LED indicator
2 Connector for
programmer
3 Connector for
10BASE5
4 Connector for
10BASE-T
5 12 VDC power
supply input terminal
6 Reset switch
Function
4-4
JW-50FL
LNK
S0
TX
S1
RX
S2
S3
DC12V
S4
TEST
S5
PER
S6
HER
S7
Advertisement
Table of Contents
