Table of Contents
Advertisement
4-3 Z-336J
1Display panel
Name
Display panel
1
2 Connector for programmer
3 Connector for 10BASE-T
4 Connector for 10BASE5
5 Switch SW6
12 VDC power supply
6
input terminal
7 Module No. switch
8 Reset switch
Number of communication
9
boards
Switch SWA
0 Switch SW1
9Switch SWA
Factory setting
: ON
5Switch SW6
(Factory setting: ON)
Displays this board operating status using LEDs.
LN
Lights when communicating normally.
TX
Blink at transmitting data.
RX
Blink at receiving data.
12 V
Lights when 12 VDC is supplied. (Only when 10BASE5 is used.)
T
Lights at test mode. (Normally, this is not used.)
PE
Lights at parameter setting error.
HE
Lights at this board error.
Displays the station number when operating normally. Displays an error
S0 to S7
code if an error occurs.
Connect a JW-14PG programmer or similar equipment to set the
parameters on this board.
Connect the 10BASE-T coaxial cable.
Connect the 10BASE5 coaxial cable.
Make sure to slide the lock securely to the "lock" position.
The shield on the cable between a 10BASE-T connector and a
ON
10BASE5 connector and the FG (base) on this module will be shorted
together.
The shield on the cable between a 10BASE-T connector and a
OFF
10BASE5 connector is not shorted to the base.
- Ground the FG line on the 12 VDC connector separately.
When 10BASE5 is used, connect a commercially available DC power
supply that is designed to supply power to transceivers. The DC power
supply must provide 12VDC ±5% and 0.5 A or more.
Specify a module number from 0 to 6.
- Be careful do not use the same number for another option board.
Only used by SHARP engineers. Users should not press this switch.
Specify the number of communication boards actually installed
(including the Z-336J).
- See pages 5-3 to 5-7.
No need to set this switch for the Z-336J. (Always set to OFF (default).)
4-3
Chapter 4: Name and Function of Each Part
0Switch SW1
Factory setting
: ON
612 VDC power supply input terminal
Function
8Reset switch
7Module No. switch SW4
(Factory setting: 0)
2Connector for programmer
3Connector for 10BASE-T
4Connector for 10BASE5
4
Advertisement
Table of Contents
