10Base-T Cable; 10Base-T/Optical Converter, Repeater - Sharp JW-20FL5 User Manual

Fl-net module (board)
Table of Contents

Advertisement

(2) 10BASE-T cable

This cable is also called "twisted pair cable" or "twisted couple cable." Two copper wires are twisted
around each other as a pair. These pairs are bundled together in sets and covered with external
insulating cover. The following types are available.
STP cable with a shield, and UTP cable without a shield.
A cross cable can be directly connected between nodes and straight cable can connect nodes
through a hub.
The maximum transfer speed of 10BASE-T cable is 10M bps and the maximum length is 100 m. The
connectors at both ends of the cable are 8-pole modular connectors specified in ISO8877.
Use category 5 compatible 10BASE-T cable for an FL-net.

(3) 10BASE-T/optical converter, repeater

This device is used to convert electrical signals on a 10BASE-T cable into optical signals.
A FOIRL (Fiber Optic Inter Repeater Link) is used to connect between repeaters and a 10BASE-FL
with terminals. This is used to prevent problems caused by electrical noise and to extend a cable's
length.
10BASE-T/optical converter, repeater for Ethernet use
10BASE-T
Pair 2
Pair 1
Pair 3
Pair 4
10BASE-T cable for Ethernet use
MLL connector (male)
RJ45 (female)
15-41
Chapter 15: Appendix
1
2
3
4
5
6
7
8
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jw-20fltJw-50flZ-336j

Table of Contents