When The Module Is Used (Host Pc: Jw50H/70H/100H) - Sharp JW-20FL5 User Manual

Chapter 11: SEND/RECEIVE function

(2) When the module is used (host PC: JW50H/70H/100H)

F-203
OPCH
F-204
SEND
PORT : Port number on which the JW-50FL is installed (0 to 7)
CH : Channel number within the specified port number (0 to 3)
In the PC program, the same port number can be called 4
times, once for each channel (CH0, CH1, CH2, and CH3).
ST : Target node number (01 to FE
fileN : Data area in the target node PC (file number)
D : Top file address of the data area in the target node PC
S : Data area top register of source station data
n : Number of data bytes transmitted (000 to 377
000)
D : Top file address of the data area in the target node PC
This node
file 0
D ->
Flag
11
Flag status during and after the operation
No response
from port
Communi-
cation jam
Communi-
cating
Normal end
Abnormal end
(error)
PORT-
S
CH-ST fileN
n
D
(H)
CH number within
the PORT number
Zero Carry Error
07357 07356 07355
0 0 1
0 0 0
1 0 0
0 1 0
0 1 1
)
, 256 bytes at
(8)
Target node
S ->
Send
Response
Non-
carry
07354
The value entered for the PORT and the actual
0
installed port number may be different.
This condition may instantaneously occur while
other send instruction is being executed.
1 However, as soon as the condition becomes clear
for the execution of an instruction, the status will
turn to "Communicating."
The communicating is being run. Once the
1 communication completes, the status will change
to either "normal end" or "abnormal end."
When the send instruction has successfully
0
completed.
0 The target node cannot be written to.
11-6
0000 to 1577
b0000 to b1777
09000 to 99777
E0000 to E1777
@ 0000 to @ 1574
@b0000 to @b1774
@09000 to @99774
@E0000 to @E1774
file N
n
Description