Commands Available During Execution Of User Program - Fujitsu SOFTUNE F2 MC-16 User Manual

CHAPTER 2 DEPENDENCE FUNCTIONS
2.3.3

Commands Available during Execution of User Program

This section explains the commands available during the execution of a user program.
■ Commands Available during Execution of User Program
This emulator debugger allows you to use certain commands during the execution of a user program.
For more details, see "■ Debugger" in "SOFTUNE Workbench Command Reference Manual".
The double circle indicates that it is available during the execution of a user program.
Table 2.3-3 shows the commands available during the execution of a user program.
Table 2.3-3 Commands Available during Execution of User Program (1 / 2)
Function
MCU reset
Displaying trace data
Clear trace data
Search trace data
Set trace acquisition data
Set trace trigger
Set filtering area
150
Restrictions
-
1. Enabled only when trace execution
*1
ended
2. Enabled only when the debug function is
in "Trace Enhancement" mode.
(only MULTITRACE)
1. Enabled only when trace execution
*1
ended
2. Enabled only when the debug function is
in "Trace Enhancement" mode.
(only MULTITRACE)
1. Enabled only when trace execution
*1
ended
2. Enabled only when the debug function is
in "Trace Enhancement" mode.
(only MULTITRACE)
Enabled only when trace execution ended
1. Enabled only when trace execution
*1
ended
2. Enabled only when the debug function is
in "Trace Enhancement" mode.
1. Enabled only when trace execution
*1
ended
2. Enabled only when the debug function is
in "Trace Enhancement" mode.
Major Commands
1.3 RESET
4.2 SHOW MULTITRACE,
4.31 SHOW TRACE(type 1)
*2
4.3 CLEAR MULTITRACE,
4.34 CLEAR TRACE
*2
4.6 SEARCH MULTITRACE,
4.37 SEARCH TRACE
*2
4.35 ENABLE TRACE,
*1
4.36 DISABLE TRACE
4.42 SET TRACETRIGGER,
4.43 SHOW TRACETRIGGER,
4.44 CANCEL TRACETRIGGER
*2
4.38 SET DATATRACEAREA,
4.40 SHOW DATATRACEAREA,
4.41 CANCEL DATATRACEAREA
*2