Fujitsu SOFTUNE F2 MC-16 User Manual page 165

Table 2.3-3 Commands Available during Execution of User Program (2 / 2)
Function
Set trace delay
Displaying execution cycle
measurement value (Timer)
Memory operation (Read/Write)
Line assembly, Disassembly
Breakpoint Settings
*1: For detail, refer to Section "2.3.6 Real-time Trace".
*2: For detail, refer to Section "2.3.1.6 Debug Function".
*3: For detail, refer to Section "2.2.1.4 Memory Mapping".
*4: For detail, refer to Section "2.3.4 Break".
Notes:
• The conditions which allow you to use the commands in Table 2.3-3 are limited to the following
cases when a user program is executed.
- [Debug] - [Run] - [Go] menu
- [Go] button on the debug toolbar
The commands in Table 2.3-3 cannot be used when the GO command is entered in the command
window.
• An error message appears if you enter a command that cannot be used during the execution of a
user program.
"E4404S Command error (MCU is busy)."
Restrictions
1. Enabled only when trace execution
*1
ended
2. Enabled only when the debug function is
in "Trace Enhancement" mode.
-
Emulation memory only operable
Read only enabled in real-time monitoring
area
Emulation memory only enabled
Real-time monitoring area, Disassembly
only enabled
Oprable only when "Breakpoint Settings
during Execution" is enabled in the
execution tab of the debug environment
dialog.
CHAPTER 2 DEPENDENCE FUNCTIONS
Major Commands
4.45 SET DELAY,
4.46 SHOW DELAY
*2
4.27 SHOW TIMER
5.1 EXAMINE,
5.2 ENTER,
5.3 SET MEMORY,
*3
5.4 SHOW MEMORY,
5.5 SEARCH MEMORY,
5.8 COMPARE,
5.9 FILL,
5.10 MOVE,
5.11 DUMP
*3
6.1 ASSEMBLE
6.2 DISASSEMBLE
3.1 SET BREAK,
3.6 CANCEL BREAK,
3.7 ENABLE BREAK,
3.8 DISABLE BREAK,
3.9 SET DATABREAK,
3.12 CANCEL DATABREAK,
3.13 ENABLE DATABREAK,
3.14 DISABLE DATABREAK
151