Fujitsu SOFTUNE F2 MC-16 User Manual page 267

The sequence event is setting by the following command.
• SET SEQUENCE :Sets sequence event
• SHOW SEQUENCE :Displays sequence event status
• CANCEL SEQUENCE :Deletes event
Notes:
• In instruction execution (/CODE), an event trigger is generated only when an instruction is executed.
This cannot be specified concurrently with other status (/READ or /WRITE).
• In the case of data event, word access from an odd address (in terms of bus access) is performed
using a byte access for twice . Note that this is the reason why even when word access from an
odd address is specified there is nothing found.
CHAPTER 2 DEPENDENCE FUNCTIONS
253