Fujitsu SOFTUNE F2 MC-16 User Manual page 321

Notes:
• This function is not available when the execution time mode is set to the time measuring mode. For
details, refer to Section "2.6.3.2 Switching Debug Function".
• If two triggers (start and end) specified as a measuring interval have occurred at the same time,
performance measuring is not performed.
• An error of approximately 10 cycles is always detected each time a user program is re-executed
because its execution has been stopped due to a breakpoint during performance measurement.
The error may exceed 10 cycles depending on the bus state.
• If the performance measurement interval (event) is re-specified during execution of a user program,
the previous measurement results are cleared.
CHAPTER 2 DEPENDENCE FUNCTIONS
307