4 - 18 MC3000 Integrator Guide
Downloading:
"Partition Name"
via "Device Parameters"
Result was: Success!
Press any key to continue
Downloading Complete Screen
Figure 4-14
On completion, press
1.
To exit IPL, select the
2.
TCM Error Messages
TCM validates the cells in the partition table when the Execute button is clicked. Cells highlighted in red contain an
error. Partition loading is disabled until all errors are corrected.
TCM Error Messages
Table 4-5
Error
Failed to build images: flash file
system DLL not loaded!
Failure finding directory xxx
Failure creating volume
Failure adding system file to image
INVALID PATH
Nothing Selected To Build
Illegal ESS ID
Disk Full
Target Disk Full
Hex file is READ ONLY
Error opening the file xxx with write
access
to return to the
menu to select the next partition to download.
ENT
IPL
item from the IPL menu.
System Reset
TCM could not load the DLL required to build images for the targeting flash
file system. Reinstall TCM or recover the DLL.
Building process failed because directory xxx was not found.
Building process failed because a certain disk volume could not be created.
Build process failed because TCM failed to add a certain system file to the
disk image.
The path for the image file to build is not valid.
In the Config Build window, no item is selected to build.
In the Build ESSID Partition window, no ESS ID was entered or the ESS ID
entered was illegal.
TCM failed to create hex image file at the selected path. Check available
disk space.
Build process failed because TCM failed to add file to the image of a disk
volume. Remove some files or increase the disk size.
The hex image file to be created exists and is read only. Delete the existing
file or change its attribute.
TCM could not open file xxx with write access. Check if file is in use.
Description/Solution