NEC Express5800 1160Xd User Manual page 36

Starting Up the System
Start up the server system as follows.
1. Make sure all external devices, such as the console, keyboard, and mouse
have been connected, and the power cords are connected (see the previous
section, "Setting Up the Server").
2. Turn on the circuit breaker or main switch to the system power source.
Note:
control unit such as an UPS (Uninterruptive Power Supply),
make sure that the power control unit is powered on.
3. Power on the console and any other external devices. Check that they start
up without any errors.
4. At the bottom rear of the server cabinet, turn on the AC power circuit
breaker for Power Bay Unit 0 and for Power Bay Unit 1 (see Figure 2-3).
Note:
power breaker being turned on, and if the operating system has been
installed, the system will automatically boot up the operating system
without further intervention (refer to the description of the SU command
in the Express5800/1160Xd/1320Xd Service Guide).
If the AC-Link function has not been enabled, then continue with this
"Starting Up the System" procedure.
2-4 System Operation
If the server power cord is connected to a power
A AC Power Circuit Breaker
Figure 2-3. AC Power Circuit Breaker
If the AC-Link function has been enabled, following the AC
A