NEC Express5800 1160Xd User Manual page 92

cmd arg1
attach iorx
(cont'd)
detach -
cellx
iorx
3-36 Service Processor
Table 3-35 HC Subcommands (cont'd)
arg2 arg3 arg4
n m p
- - -
- - -
- - -
Description
Associates the IOR Daughter Board having the
physical number x with the logical IOR Daughter
Board number m of partition n. (m: The number
recognizable by the BIOS and software.)
"p" (0-9) sets the priority.
Indicates which IOR Daughter Board is used
with a higher priority if the number of normal
CELL Boards is smaller than the number of
normal IOR Daughter Boards due to CELL
Board failure in the partition. (Smaller values
have a higher priority, and the IOR Daughter
Boards with larger values get isolated one by
one. If the priority number is the same, the one
with a smaller physical IOR Daughter Board
number has a higher priority.)
This command can be used to change the
logical IOR Daughter Board number and priority
if it has been already associated.
The logical IOR Daughter Board number must
be unique within the partition.
You cannot change the logical IOR Daughter
Board number or priority of the IOR Daughter
Board which is in the online state.
"Priority 0" is allowed one time for one partition
and a Basic I/O Board must be connected. If
any failure occurs in this IOR Daughter Board,
the partition cannot be started.
The IOR0 must have priority 0.
Used to cancel the associations between
partition numbers and CELL Boards/IOR
Daughter Boards.
You cannot detach any component that is in the
online state.
The number of CELL Boards in a partition must
be greater than the number of IOR Daughter
Boards.
Displays Help of "detach" when the argument is
omitted or an error is made.
Disassociates the CELL Board having the
physical number x from the currently associated
partition.
Disassociates the IOR Daughter Board having
the physical number x from the currently
associated partition.