NEC Express5800 1160Xd User Manual page 90

cmd arg1
help -
quit -
exit
disp -
all
part
main
iox
other
cpu
cellx
3-34 Service Processor
Table 3-35 HC Subcommands
arg2 arg3 arg4
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
Description
Displays the list of subcommands.
This command can be executed in the AC
POWER ON or DC POWER ON state.
Exits from the HC command.
Before an exit, the check subcommand is
automatically executed.
This command can be executed in the AC
POWER ON state or DC POWER ON state.
Used to display states.
Displays Help for "disp" when the argument is
omitted or an error exists.
This command can be executed in the AC
POWER ON or DC POWER ON state.
Displays all the states.
Displays the following partition division
information for each partition:
State summary
Physical CELL Board number and logical CELL
Board number
Physical IOR Daughter Board number and
logical IOR Daughter Board number
Amount of shared memory.
Displays the state of the Main Cabinet.
Installed PCIX Unit becomes a display target
after the location setting is done correctly.
Displays the state of the I/O Expansion Cabinet.
Installed PCIX Unit becomes a display target
after the location setting is done correctly.
Displays the components in which Main or I/O
Expansion Cabinet cannot be determined
because the location information is not fixed (i.e.
no location is entered after the AD command is
executed).
These components may correspond to PCIX
Unit.
Displays the state of the CPU/Memory Sub-
chassis (16-way)/(32-way).
Displays the state of the CELL Board.
"x" is the physical CELL Board number (0-7).