Sp Command List - NEC Express5800 1160Xd User Manual

SP Command List

The following table lists the SP commands by category.
CMD Command Name
DF Shut Down System Power
(override)
DN Shut Down System Power
DP System Dump
PC Power Cycle
RS Cold Reset System
UP Bring Up System
Figure 3-4. System State Transitions and System Control Commands
Table 3-16. System Control Commands
Function
The iSP turns off the DC power of the
specified partition without notifying the SW
(OS) even if it is running.
If the specified partition is in SO state, the
iSP only generates the SCI(POWBTN).
Otherwise, the iSP turns off the DC power
directly.
The iSP generates the INIT signal to the
specified partition. SW(OS) will enter its
dump routine.
The iSP turns off the DC power of the
specified partition without notifying the
SE(OS) even if it is running, turns on the DC
power, initializes HW and hands off the
control to the BIOS.
The iSP initializes the specified partition
without notifying the SW(OS) even if it is
running.
The iSP turns on the DC power of the
specified partition and initializes HW and
hands off the control to the BIOS. The BIOS
boots the operating system.
DC OF F
UP /P C
DN /DF
DF
P C
RS
UP /P C/RS
DC ON
N ot r u n n in g
NML MNT
Mode Mode
X X
X X
X X
X X
X
X
X X
DN /DP
(on ly t r igger )
Rea dy
SW r u n n in g
Service Processor 3-15
iSP
State
m
m
m
m
m
m