Maintaining the Defibrillator
This section contains information about maintaining and cleaning the HP
CodeMaster 100.
Changing the Recorder Paper
To change the recorder paper, perform the following steps:
1 Slide the recorder door to the right of the defibrillator as shown Figure
2 Pull up on the plastic removal tag to remove the empty or low paper roll.
Figure 13-1
Changing the Recorder Paper
3 Place a new roll of recorder paper (HP 40457C/D) in the recorder so that
4 Pull the end of the paper past the recorder platen.
5 While holding the recorder door open (to the right), press the platen
6 Allow the door to close over the platen roller.
13-1. The paper platen will tilt up.
the paper unrolls from the top of the roll and the grid faces down as it
comes out of the recorder.
down over the paper.
CodeMaster 100
13-1
13-7