Table of Contents
Advertisement
Installation
Installing the Handset Battery
1. Remove the battery cover from the handset by pressing the latch and sliding the cover down
until it comes off the handset.
2. Slide the top of the battery into position, then lower the bottom portion into place. Note that the
battery has positive and negative indications. Make sure to place the battery in the handset so
the negative is on the left and positive is on the right (the metal contacts should face down
toward the phone).
3. Securely close the battery compartment cover by sliding it up until it snaps into place.
Charging the Handset Battery
The rechargeable Nickel-Cadmium battery pack must be fully charged before using your phone for the first time. Charge the battery
without interruption for 5 hours. The unique design of the telephone and charger allows you to place the handset in the Desktop
Charger with or without the Belt Clip attached.
1. Place the phone in the front slot of the desktop charger. The dial pad should be facing out in order for the battery contacts to
connect.
2. Make sure the CHARGE 1 LED lights. If the LED doesn't light, check to see that the AC adapter is plugged in, and that the
handset is making good contact with the battery contacts.
Charging the Spare Battery
The desktop charger of your phone is equipped with a Battery Charger for charging the optional spare battery. The battery pack
can be charged either in or out of the handset.
1. Place the spare battery into the battery slot. In order for the battery to charge correctly,
the metal contacts must face down into the charger
If the battery is not positioned correctly, the CHARGE 2 LED will not light.
2. Slide the spare battery pack into the second slot in the charger until the retaining clip snaps
over the top of the pack.
Make sure the CHARGE 2 LED lights. If the LED does not light, check to see that the AC
Adaptor is plugged in, and that the battery pack is seated into the Charging Compartment. Charge
the battery pack without interruption for 12-15 hours.
When charging is complete, press the latch back slightly to remove the battery if it is needed.
Otherwise, leave the battery in the Charging Compartment. It will not overcharge.
Low Battery Indicator
When the battery in the handset is low and needs to be charged, you will see a "LOW" warning icon on the display.
Return the handset to the desktop charger for charging or replace the handset battery with the spare battery.
On a Call
All keys and functions are available
Handset beeps once every 3 seconds
Complete your call as quickly as possible
Replace the battery pack within 20 seconds to continue call
1-10
When the Low Battery Indicator Appears While
In Standby Mode
None of the buttons operate
Handset beeps every 15 seconds for 3 minutes
Cannot make or receive a call
Replace battery pack before making a call
Advertisement
Chapters
Table of Contents
