Epson Aculaser CX16NF User Manual page 34

Note:
Manual transmission cannot be used together with duplex (double-sided) document transmission.
1. Load the document into the ADF.
Note:
❏ When sending a fax manually, load the document into the ADF. An error will occur if the
document is placed on the original glass.
❏ For details on loading the document into the ADF, refer to "Sending a Fax Using the ADF" on
page 17.
2. If desired, adjust the image quality.
Note:
The document image quality can be adjusted. For details, refer to "Adjusting the Image Quality" on
page 21.
3. Pick up the handset and check that the dial tone can be heard.
4. Specify the fax number of the recipient by using the telephone to dial the fax number.
Note:
❏ The fax number of the recipient can also specified using the keypad in the control panel of this
machine.
❏ If Pulse is selected as the telephone line type, press the key to temporarily change the line type to
Tone.
5. After finishing talking on the phone, the recipient should press the necessary key to start receiving
the fax.
Once the recipient's fax machine is ready, a beep is sounded.
6. Press the Start key to begin scanning and sending the fax.
7. Replace the handset to its cradle.
Note:
To stop the transmission, press the Stop/Reset key. A message appears, requesting confirmation to
cancel the setting. Select YES, and then press the Select key.
AcuLaser CX16NF Facsimile User's Guide
Sending Faxes 34