Sending A Fax Manually Using The On Hook Key; Sending A Fax To A Combination Of Fax Numbers (Chain Dial) - Epson Aculaser CX16NF User Manual

Sending a Fax Manually Using the On hook Key

Note:
Manual transmission cannot be used together with duplex (double-sided) document transmission.
1. Load the document into the ADF.
Note:
❏ When sending a fax manually, load the document into the ADF. An error will occur if the
document is placed on the original glass.
❏ For details on loading the document into the ADF, refer to "Sending a Fax Using the ADF" on
page 17.
2. If desired, adjust the image quality.
Note:
The document image quality can be adjusted. For details, refer to "Adjusting the Image Quality" on
page 21.
3. Press the On hook key.
4. Specify the fax number of the recipient.
Note:
❏ The keys for registered destinations can be used even if the On hook key has been pressed. For
details, refer to "Specifying a Recipient" on page 22. (Group dial destinations cannot be
specified.)
❏ If Pulse is selected as the telephone line type, press the key to temporarily change the line type to
Tone.
5. Press the Start key to begin scanning and sending the fax.
Note:
To stop the transmission, press the Stop/Reset key. A message appears, requesting confirmation to
cancel the setting. Select YES, and then press the Select key.

Sending a Fax to a Combination of Fax Numbers (Chain Dial)

Multiple fax numbers can be combined to specify the recipients. This is called "chain dialing".
AcuLaser CX16NF Facsimile User's Guide
Sending Faxes 35