Adjusting The Image Quality; Adjusting The Resolution - Epson Aculaser CX16NF User Manual

Note:
❏ To stop the transmission, press the Stop/Reset key. A message appears, requesting confirmation
to cancel the setting. Select YES, and then press the Select key.
❏ If the fax could not be sent (for example, because the line was busy), the automatic redial function
will try sending the transmission again.
If the fax could not be sent with the automatic redial function, a TX Result Report can be printed.
For details, refer to "TX RESULT REPORT" on page 64.
❏ If you want to cancel a scanned document queued for transmission or a fax waiting to be
redialed, select CANCEL RESERV. from the menu. For details, refer to "Canceling a Queued
Transmission" on page 36.
❏ If memory is nearly full, scanning of the document is stopped and a message appears, allowing
you to select whether to start the transmission or cancel that transmission job. If the selection is
made to cancel the job, the pages of the document that have been scanned for that job are deleted.
If the selection is made to begin the transmission, transmission begins. After the scanned pages
have been sent, scanning of the document starts again.

Adjusting the Image Quality

The image quality of a document can be adjusted before it is sent as a fax.

Adjusting the Resolution

1. Press the u or d key to select the current fax image quality, and then press the Select key.
Note:
STD/TEXT, FINE/TEXT, S-FINE/TEXT, STD/PHOTO, FINE/PHOTO or S-FINE/PHOTO may
appear, depending on the setting selected for FAX TX OPERATION in the UTILITY menu.
2. Check that QUALITY(ORIGINAL) is selected, and then press the Select key.
3. Press the u or d key to select the fax resolution, and then press the Select key.
The resolution is adjusted.
Note:
Select the resolution appropriate for the document.
❏ STD/TEXT: Select this setting for documents containing handwriting or for computer printouts.
AcuLaser CX16NF Facsimile User's Guide
Sending Faxes 21