NEC NEFAX655e Manual page 130

Set Printer
PCL4 ENHANCE
6 - 5
Allows users to select PCL4 printer emulation which supports 300 dpi. If the
LCD displays, "PCL4/GDI CHANGE, RESTART YOUR FAX" because
memory reallocation (refer to Memory required for printer), it is necessary to
power OFF the fax machine and then turn the power back ON (wait
approximately 6 seconds before turning the unit back ON).
Note: Be sure to print (clear) any documents from Fax memory before
selecting PCL4 ENHANCE.
1
Press the Program key and scroll through
the menus until you reach the Set Printer
menu and press YES.
2
Press 7 or scroll down to the PCL4
Enhance menu and press YES.
3
Select either ON or OFF depending on
your needs. Press YES to accept this data
into memory.
4
If you chose YES, you must restart the unit
to make this change active.
SET PRINTER?
YES / or 1-8
7 PCL4 ENHANCE?
OK=YES
ON *OFF
-SELECT&PUSH"YES"-
PCL4/GDI CHANGE
RESTART YOUR FAX
PC Printing & Scanning