NEC NEFAX655e Manual page 89

Header
The header prints the sender machine name, fax number, date/time, and page number at
the top of the sheet at the remote location. This is required by the FCC in the USA and is
regulated in other ways in other countries. In the USA you will have one of the
following options.
Facsimile Programming
• Inside the Body: This places the header in the first 5mm of the copy top. It does
not shift the copy down. Some copy may be overwritten.
• Outside the Body: This places the header in the first 5mm of the copy top. It
then starts the body below this. Depending on the remote machine settings one
of three things happen: 1) because the copy is not a full page, the copy fits
below the header at 100%, 2) the copy is reduced to fit the page, or 3) the copy
is split into two pages at 100%.
1
Press the Program key and scroll through the
menus until you reach the TX Operation Menu.
Press YES to begin programming.
2
Press 4 or scroll down to the Header menu and
press YES.
3
Select if you wish to turn the header ON or OFF
and press YES.
Note: In the USA, the header is required on all facsimile transmissions. It is
unlawful to turn this OFF.
TX Operation
TX OPERATION?
YES / or 1-4
4 HEADER?
OK=YES
*ON OFF
-SELECT&PUSH"YES"-
4 - 30