Figure 1.86 [Add Filter] Window; Table 1.121 Setting And Display Items In The [Add Filter] Window - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations

TABLE 1.121 Setting and display items in the [Add Filter] window

Items
Protocol
Sets the protocol for the IP filtering. You can select one of the following items from the
pull-down menu:

HTTP

HTTPS

Telnet

SSH

SNMP
Access Control
Sets whether to execute access control.

Disable: Permits access by all IP addresses via the protocol selected in [Protocol].
Selecting this disables input to [IP Address] and [Subnet Mask].

Enable: Specifies [IP Address] and [Subnet Mask] to permit access via the protocol
selected in [Protocol].
IP Address
Sets the IP address (for IPv4 or IPv6) that will have permission to connect.
Remarks
For IPv4, to permit connection by only a specific IP address in a subnet, specify the IP
address and then "255.255.255.255" in [Subnet Mask]. For IPv6, the prefix length is
displayed.
Example: Permitting access from a specific IP address range (e.g.,
192.168.60.60/255.255.255.0)
IP Address: 192.168.60.60
Subnet Mask: 255.255.255.0
(because the IP address is used with a 24-bit subnet mask)

The above setting will enable access not only from the IP address 192.168.60.60, but
also from IP addresses within the subnet 192.168.60.0/24.

FIGURE 1.86 [Add Filter] window

Description